Thermostat Operation after Power Outage

Discussion in 'C-Bus Toolkit and C-Gate Software' started by tidefan, Sep 26, 2013.

  1. tidefan

    tidefan

    Joined:
    Jan 6, 2009
    Messages:
    45
    Likes Received:
    0
    Location:
    Alabama
    Can someone comment/explain how a Clipsal Thermostat 5070 will operate after a power outage. For example, if the thermostat is in heat mode, after a loss of power will the thermostat revert back to the state it was in prior to the loss of power? Is this different depending on the amount of time without power?
     
    tidefan, Sep 26, 2013
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. SENPILL After Power Failure....

  2. 06-019-1 Enable & Disable Status After A Power Failure

  3. C-Gate <-> PICED loses status after reconnect after 2hr timeout

  4. SENPILL (Multisensor) Occupancy sensor enabled after power failure

  5. Cbus after a power flick !

  6. Switcher issue after power outage

  7. 4 Zone Thermostat goes to Manual after download ??

  8. Power ON Multi room audio remote amplifier after power reset?

Loading...