Set up Lets Encrypt??

How does one set up Lets Encrypt to obtain a certificate?

eg: Domain to use is
fred.bear.net
DDNS service freedns.afraid.org

In Piced
Project Details->DDNS/SSL

Click on DDNS Enabled
DDNS Service - choose freedns.afraid.org
Host Name - fred.bear.net
User Name - your freedns username
Password - your freedns username password or a special token

DNS for Lets encrypt -
Home Controller DNS name - fred.bear.net

Upload project to Wiser2

Is there anything else that is needed to be done for it to obtain the certificate?
Is there a way to check Wiser2 to see if a certificate has been created?

Thanks

 

Did you ever get this to work? I don't need DDNS as have AWS serving all my addresses and cannot get lets encrypt to work, or uploading my own certificate (as i have an AD domain as well).

 

No, have not looked at it for awhile.
Will look into it again soon.

 

trying to work this out myself. Will let you know if I have success.

 

Have just been doing some testing.
Took the wiser up to the study and plugged it into the network and plugged the HDMI out to a monitor.
Plugged in a keyboard and mouse.
NOT connected to the C-Bus network for this.

The network output/input calls are monitored by Graylog so I can see what network calls are being made.

Did a factory reset.
Connected via keyboard/mouse/HDMI using the default admin user and default admin password.
Had a look at the setup which showed it is connected to the home network via DHCP.
Tried to log in via network IP address port 80 but it still says that you must use HTTPS for network connection.
So it still does not allow local connection.

I set up the DDNS using zoneedit.


During the reboot, I could see that it calls the NTP servers to get the current time.
After a few minutes, it contacts zoneedit.
Looking at the zoneedit dynamic records, I can see that the call works and the DDNS is showing my IP address.
So that part is working.

I update the config via piced and added the zoneedit information (host Name xxx.yyy.net) and added the same for the Lets Encrypt Home Controller DNS Name xxx.yyy.net.

I uploaded the config to the Wiser.

After the reboot, I again could see calls to NTP and zoneedit.
But no other outgoing calls.

So how does it call Lets Encrypt to get the SSL certificate?

I then unplugged the wiser and put it back where it normally goes and connected it to the CBus network.

Upon reboot, it calls NTP and zoneedit.

End result
Still cannot connect VIA Lan on Port 80 as it assumes we are NOT local!!
Cannot figure out how to setup Lets Encrypt.
Cannot connect via HTTPS as there is NO certificate

Is there a document that explains how to set up and use Lets Encrypt for the Wiser2 box?