Power supply issues

Discussion in 'C-Bus Toolkit and C-Gate Software' started by mobsta, Nov 5, 2013.

  1. mobsta

    mobsta

    Joined:
    Oct 1, 2013
    Messages:
    4
    Likes Received:
    0
    Location:
    Busville
    I noticed today while working on a current project in toolkit that I had 600mA supply and I was drawing 661mA...hence toolkit suggested I require another 61mA. But! I have 5 on board power supply's which would equal 1000mA(1A)

    So why is toolkit not showing this? The five relays are in the database and network so that proves none are missing. Any thoughts??
     
    mobsta, Nov 5, 2013
    #1
  2. mobsta

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,574
    Likes Received:
    186
    Location:
    Adelaide, Australia
    You have probably entered the wrong part number. Toolkit can't tell the difference between power supply and non-power supply output units. Non power supply units have a 'P' suffix (yes it's that way around!). You will most likely find 2 of your output units have been entered with a 'P' suffix. Just change the part numbers.
     
    Ashley, Nov 5, 2013
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Ceiling Sweep Fans and Low Power Supply

  2. Power Supply 5100PS not recoginzed in Toolkit

  3. Choosing the right power supply

  4. Erratic Mains power supply issues

  5. Can't Edit 5500PS (C-Bus Power Supply)

  6. power supply requirements

  7. Power Supply Not Showing on Network

  8. Power Supply Issues

Loading...