LED Assignment on SENPIRSS Changes on its own

Discussion in 'C-Bus Toolkit and C-Gate Software' started by Charlie Crackle, Jan 10, 2005.

  1. Charlie Crackle

    Charlie Crackle

    Joined:
    Aug 3, 2004
    Messages:
    815
    Likes Received:
    8
    Location:
    Melbourne
    Further to....

    http://www.cbusforums.com/forums/showthread.php?t=612

    (But this time on a SENPIRSS)

    I have noticed that when I edit the time using the ... the Status for the LED assigenment moves to the top.

    I have the LED Assignment on Block 4 and SE Ticked (so the led goes on when movement detected)

    I have block 2 setup with DA. When I Edit the time the status moves from Block 4 to Block 1 when you apply.


    Also found another bug while playing. If you have the LED status in block 4 then click LI block 2 the Status moves to block 1

    Another bug (which I can not remember what I did to get it) was to get the STATUS in blocks 1 and 4 !!
    [​IMG]
     

    Attached Files:

    Charlie Crackle, Jan 10, 2005
    #1
  2. Charlie Crackle

    daniel C-Busser Moderator

    Joined:
    Jul 26, 2004
    Messages:
    766
    Likes Received:
    20
    Location:
    Adelaide
    The Cracklemaster strikes again!

    Defect ID #4168

    Thanks Charlie. We'll look into that!

    Daniel
     
    daniel, Jan 10, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Installing own system

  2. SENPIRSS Wierdness

  3. Help, my C-BUS has a mind of its own...

  4. Why can't consumers perform their own electrical work?

  5. Linked smoke detectors but still own dry contacts per detector

  6. DLT has no led block assignment

  7. Wiser Weather Station - using Power Meters for your own data

  8. Built my own http interface using Node.JS

Loading...