"esc" key did not halt

Discussion in 'C-Bus Toolkit and C-Gate Software' started by Dave Byron, Jun 15, 2005.

  1. Dave Byron

    Dave Byron

    Joined:
    Aug 3, 2004
    Messages:
    835
    Likes Received:
    0
    Location:
    Casurina
    In Toolkit when doing a scan there a window that indicates pressing "esc" will stop the scan.
    When i press it just starts the scan again, any ideas
    I wanted just unit data not units group assinment, like a particial in v2

    dave
     
    Dave Byron, Jun 15, 2005
    #1
  2. Dave Byron

    Richo

    Joined:
    Jul 26, 2004
    Messages:
    1,257
    Likes Received:
    0
    Location:
    Adelaide
    For a quick scan with no group info use the "scan new" button. Not sure on why escape isn't working for you, I'll make a note to check it.
     
    Richo, Jun 16, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Back Space key does not work in the CNI Port Box

  2. So did *anyone* here go to the Melbourne Product Launch last week?

  3. Hardware key: Key initialize failed (DRIVER NOT INSTALLED)

  4. Scene does not work on 5753PEIRL Virtual key 5

  5. Toolkit does not remember indicator 'brightness after key pressed' setting.

  6. Dimmer Channels not responding to software & key input units

  7. Where did the C-bus light go ???

  8. Saturn key delay before next key press

Loading...