Dead Wiser??

Hello All,

I was unable to connect to my wiser so i rebooted it as I have done several times, unfortunately that just seemed to make things worse.

I get the following LED now

C-bus: off
MRA:Yellow
Power: Green
zigbee:Yellow
wifi: off

I have tried a partial reset and a full factory reset several times.

the full factory reset just leaves me with
C-bus: off
MRA: off
Power: Green
zigbee:Red
wifi: off


I have held the reset button in for 30 seconds.

I have put the latest wiser2 image on a usb and plugged it but still no joy.

Any suggestion would be greatly appreciated.

Maybe it's the battery? I will look at that tomorrow

 

Hi,

I've signed up in hopes someone can shed some light on this.
I also seem to have a dead wiser.
MRA yellow, POWER green, all other lights are off.
Tried a partial / full reset and only POWER light is green until I reset it where the MRA will be yellow upon boot.
Can't seem to get a LAN connection (no activity lights with cat cable plugged in), and can't get a display to the TV via the HDMI.
Have tried changing the battery and no different.

Is this a dead unit?

 

I've had the same problem. Did you figure something out?

 

I too have the same problem, has anyone been able to getting it going again?? or any ideas of steps to try beside reset. I can still see the unit in toolkit and was still controlling scenes until factory reset but can no longer be found on the network.

 

I also have the same problem. Has anyone solved it ?