Adding Security application to Toolkit

Discussion in 'C-Bus Toolkit and C-Gate Software' started by GlenF, Oct 14, 2018.

  1. GlenF

    GlenF

    Joined:
    Jan 22, 2006
    Messages:
    130
    Likes Received:
    0
    Hi all,

    I am wondering how I access the security application in toolkit? I have a comfort alarm connected and in the log file it shows 208 security elements, however, there is no tab in the applications for security. Also, when I try to add, there is no 208 available.

    I understand I can allow legacy cbus applications but this does not seem to be the right answer. I am only trying to configure the data so I can label the security zones.

    Thanks
    Glen
     
    Last edited: Oct 14, 2018
    GlenF, Oct 14, 2018
    #1
  2. GlenF

    Wonkey

    Joined:
    Aug 3, 2004
    Messages:
    395
    Likes Received:
    37
    Location:
    Adelaide
    The Security application is for communications between your alarm panel and C-Bus not for you to modify.
    To use the features which would typically have been on a touch screen you use PICED and select the component to do the required action. ARM DISARM etc.
    Zones are just numbered zone 1 ,2 ,3 etc however in PICED you could display ZONE 1 as Front Door if you wish.
    Open PICED up and load the Example Projects Features it may help explain.
    Colin
     
    Wonkey, Oct 14, 2018
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Security Application D0

  2. Adding application beyond 113 (71 HEX)

  3. Q: C-Bus security Application, status report 1?

  4. New V4 telephony & security application

  5. Security Application

  6. Using Paradox on the Security Application

  7. Security Application Controlling two alarms

  8. Adding application to another network

Loading...