Wizard on Homegate startup

Using Homegate 2.6, I have setup for auto loading project on startup but it is running the project select wizard at start. Does anyone know if there is a parameter inclusion to deselect the wizard from running. (the wizard feature was not in V2)

 

Check the available command line options in the help file. Uisng the command line options it is possible to have Homegate automatically load a project and go into run mode.

 

The wizard will only be displayed if the project you have listed in the command-line parameters does not exist. Check that if there are spaces within the project path or file name that you have the file name in "double quotes". As Anthony suggested, see the help file under command-line parameters for more details.

 

Thanks for your help gentlemen its working fine now. I had ommitted the <:> in <C:\CLIPSAL> in the file path. A small mistake but a very important one.

 

I have entered a issue in our issue tracking software along the lines that a meaningful error message should be displayed in this circumstance rather than just launching the wizard. (#5327).