wiser2 and CNI2

Hello i'm an Electrical Engineering student from Cambodia and i have a project with automation. Now i work with home automation system but I have a problems with wiser 2 and CNI2 connection. I'm not clear how the connection of wiser2 and CNI2. I'm not good at in Network, please help to explain me.

I have :

-Wi-fi router
- Wisr2 home controller
-5500CNI2
-5500PC interface
-12 channels free relay (L5512RVF)
-Saturn 5 Gang key input DLT WE

Should I have to connect the 5500cni2 directly to wiser2 or directly to Wi-fi router?
Please help me!

 

Anyone can help me, please?

 

Wiser2 and CNI2 connection

Anyone can help me please?

 

If you have a Wiser 2 you don't need a CNI, nor do you need a PC interface. You just connect your Wiser 2 to your IP network (WiFi or cabled Ethernet choice is yours) and connect your C-bus network to the c-bus interface on the Wiser 2.

If you google Wiser and Wiser2 you will find the installation instructions.

 

OK, so do you mean that I have to connect the L5512RVF (12 channel free relay ) to 5500PC Interface and then to wiser2 ? Can you explain me clearly?

Because you know the c-bus interface on wiser 2 uses a 2-terminal plug for
c-bus device. This below is a 2-terminal on wiser2:

C-Bus - ( Blue & white + Orange & white)
C-Bus + (Blue + orange) that use the UTP category 5e. So the other side of the cable how could i connect to the c-bus connection.

Anyone can help me or show the connection photo or draw the wire connection to each device?

Please help me!

 

Wiser2 and c-bus device connection

OK, so do you mean that I have to connect the L5512RVF (12 channel free relay ) to 5500PC Interface and then to wiser2 ? Can you explain me clearly?

Because you know the c-bus interface on wiser 2 uses a 2-terminal plug for
c-bus device. This below is a 2-terminal on wiser2:

C-Bus - ( Blue & white + Orange & white)
C-Bus + (Blue + orange) that use the UTP category 5e. So the other side of the cable how could i connect to the c-bus connection.

Anyone can help me or show the connection photo or draw the wire connection to each device?

Please help me!

 

Wiser2 and c-bus device connection

who can help me please?
Thank in advance.

 

This is all very basic stuff and is described in detail in the documentation freely available on the CIS website:

www.clipsal.com.au/cis

You will also find all the training course material that takes you through this step by step. If you want to learn you need to put in a bit of effort

 

Hi horm,

Please call 1300 722 247 and press 2 and then press 7 go to CIS help line.

 

I call but not reach this number