Unit parameter in PAC

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by Rossco, Sep 21, 2005.

  1. Rossco

    Rossco

    Joined:
    Aug 15, 2004
    Messages:
    61
    Likes Received:
    0
    Location:
    Victoria
    I was wondering why the PAC unit doesnt have the getunitparameter in Logic, it has been greyed out.

    With this it would allow a b/w touch screen to adjust temperatures for control and have the PAC unit doing the logic without using a Minder.
     
    Rossco, Sep 21, 2005
    #1
  2. Rossco

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    In HomeGate, "monitor" components are used to read the unit parameters from temperature sensors and light level sensors. The logic then uses the data obtained by these monitor components. The PAC doesn't have monitor components, so there is no unit parameter data for it to read.

    The PAC might get updated at some stage to support this, but the much better solution is to update the PAC to support the measurement application so that it can use any sort of data from the General Input Unit.
     
    Darren, Sep 22, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Install New Unit Function

  2. 06-021-1 PIR Disable Parameter

  3. TAG as Procedure (parameter : ????????)

  4. Unit parameters for PAC

  5. pac unit for scenes

  6. Pass Tagname as parameter into a function?

  7. Logic on PAC causes unit reset (works fine in PICED)

  8. PAC unit not keeping time

Loading...