Underfloor heating control

Discussion in 'General Discussion' started by buddy_nz, Nov 11, 2019.

  1. buddy_nz

    buddy_nz

    Joined:
    Nov 11, 2019
    Messages:
    1
    Likes Received:
    0
    Hi All,

    Apologies if this has been discussed before.

    Is anyone able to tell me if it's possible or if there is a better way to do this?
    I have a heat pump unit that runs my underfloor heating, it only requires either to be on or off. I was thinking of just using a c-bus relay to control it. Is it possible to use a temperature sensor to control a c-bus relay at a set temp?

    Thanks in advance.
     
    buddy_nz, Nov 11, 2019
    #1
  2. buddy_nz

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,524
    Likes Received:
    173
    Location:
    Adelaide, Australia
    Did you try searching 'underfloor heating'? There is lots of information there on exactly what you are trying to do.
     
    Ashley, Nov 14, 2019
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. C-Bus for Underfloor Heating Zone Control

  2. CBUS Heating Control

  3. solar heating control

  4. Heating control

  5. Control heating/cooling from RS232 (Advantage Air GenIII)

  6. Underfloor heating controls

  7. Underfloor heating

  8. Control heating without HVAC unit

Loading...