ToolKit PCU5500 Error 2080

Discussion in 'C-Bus Toolkit and C-Gate Software' started by cracker, May 29, 2013.

  1. cracker

    cracker

    Joined:
    May 29, 2013
    Messages:
    1
    Likes Received:
    0
    Location:
    melbourne
    Hi all
    I have installed a c-bus system over 2 years ago and have connected to my pc using thePCU5500 a number of times. I have had problems in the past but connected by changing the virtual port a number of times.
    When i now open the tool kit it comes up with error 2080 eventhough i can see the pcu on my computer devices and it says it is working properly. The toolkit then closed down the project option and i cannot get to any of the projects. This never happened in the past even if i could not connect it showed all the projects on the lef and functions on top.

    any ideas?????
     
    cracker, May 29, 2013
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.