Testing Neo LEDs

I recently returned a 8 gang Neo switch with a faulty LED.

I was told a test for the LEDs is to hold down the top two switches and then apply power. All the LEDs flash in sequence for several minutes or until power is removed.

Probably not widely known. Good for testing or a demo.

It works - and is very pretty.

 

LED Test mode

Hi,

This also works for DLTs. Hold down any two buttons when you power it up and it'll tell you it's Serial Number, Applications and the Network Voltage while putting on a pretty light show.

Cheers,
Mark.

 

Any Tricks for A Saturn Switch as I have two that the Leds are Sus On. Or is that Not On ??.

 

Hi Sam,

Saturn is the same as NEO. Just hold down any 2 buttons while you power it up.

Cheers,
MArk.

 

Thanks For that I will Have to Try it out.