Temp Sensor with CTC

If i monitor my Temp sensor in PICED or Homegate using Monitor every thing is fine
I set the unit addres and I get the temp
From PICED I then transfer to CTC

Nothing
Well it says ?oF

Any ideas
Also the example in the logic set for Heating/cooling control
Which sensors is that using?

thanks
Mike

 

I had the same problem with version 3.2 and a older square temp sensor, now since installed version 3.3 it reads the temp fine.

 

We discovered recently that this problem can be caused by the temperature sensor having its "error" flag set. This gets cleared by doing a scan with the ToolKit, but only with version 1.1.6 or before, or with the next version about to be released (1.1.10).