Switcher issue after power outage

Discussion in 'Multi-Room Audio (MRA) and MARPA' started by smeebag, Dec 2, 2009.

  1. smeebag

    smeebag

    Joined:
    Aug 14, 2008
    Messages:
    16
    Likes Received:
    0
    Hi all.

    We have and installation which is working fine with 8 zones.
    It seems however whenever the power goes out, one or two zones stop working. Pressing the zone buttons on the front of the switcher and cycling through 1 or 2 sources seems to "wake it up". Its always zone 8, but occasionally one or two of the others. Not a big problem, just annoying.

    Is this normal?
     
    smeebag, Dec 2, 2009
    #1
  2. smeebag

    RatDeSewer

    Joined:
    Sep 24, 2004
    Messages:
    39
    Likes Received:
    0
    Location:
    Henley Beach
    There was an issue identified early this year that larger systems may do this on powerup. The fix is to have the amplifier firmware upgraded. Please contact CIS tech support.

    RDS
     
    RatDeSewer, Dec 18, 2009
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. SENPILL After Power Failure....

  2. 06-019-1 Enable & Disable Status After A Power Failure

  3. C-Gate <-> PICED loses status after reconnect after 2hr timeout

  4. SENPILL (Multisensor) Occupancy sensor enabled after power failure

  5. MRA Matrix Switcher - AM issue

  6. Thermostat Operation after Power Outage

  7. Matrix switcher internal power supply

  8. Power ON Multi room audio remote amplifier after power reset?

Loading...