Sending a CTRL+S to put PICED into Operation mode

Hi Everybody...
Anyone know if you can use logic or any other way to put a project into Operation mode rather than using the keyboard shortcut key - CTRL+S
Can it be done in a logic module and activated by pressing a button on the screen to activate.
Or can you do it with a special command for a button.

I have been looking all over PICED but haven't found anything yet.
Any ideas...

 

Operation mode is not for PICED, it's for Homegate or Schedule plus.
Piced support simulation mode, just as a short-term test to see if things work as you would expect before transferring to the touch screen.
Though PICED, Homegate and Schedule plus all look similar, PICED is for programming the touch screens, and the other two are designed to live on a PC as the control interface to C-Bus.

Now within HOME gate and SP you can have a button and clicking on any component with the Operation Mode Special Function property set.

 

I looked every were,
There is no special function to do this.
Any other ideas,
All i need to do is push a CTRL+S to the program.

 

So you are using Schedule Plus or Homegate NOT PICED.
In SP open a C-Bus Button or Text Button click on the Special function Tab and select Operation Mode Enter or Exit

 

Thanks for that, but im not seeing that option, i am using piced 4.13.1 and i dont see it in the list.
Ill check again tomorrow morning.

 

Trevor you are using the wrong software

 

Got it,
I am also using SP, i did find it in that menu.
Appreciate the help.