Reboot AC and level of lights show 100%, yet are not

Discussion in 'C-Bus Automation Controllers' started by ssaunders, Aug 16, 2022.

  1. ssaunders

    ssaunders

    Joined:
    Dec 17, 2008
    Messages:
    232
    Likes Received:
    31
    Location:
    Melbourne
    Has anyone encountered a situation where when one reboots a SHAC/NAC that the apparent level of some objects that were ramped to a level go to an indicated 255/100%?

    The lights on units are still dimmed to the present level, and the AC knows they're on, but seems to have no idea what their current level actually is so apparently assumes full on.

    LSS5500NAC on v1.11.0, plus a 5500SHAC on 1.10.0 both do the same, both hosted on local network.

    This is weird.

    I have two CBus networks: 254/253 with a bridge between set to pass messages to identical GAs on both networks. After the reboot the objects on network 253 dimmers/etc. show the correct value on both 0 & 253 objects in AC. But GAs with dimmers/etc. on the local network 254 (AC 0) show at level 255, and visualisations reflect that too.

    I'm out of ideas.
     
    ssaunders, Aug 16, 2022
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. SENPIRSS (Learn Capable) does not show status

  2. Are DLT back lights next to beds too bright?

  3. Can "GET <blah> LEVEL" be structured to only tell me what groups are on?

  4. eDLT Key Function set to "Soft Down / Soft Up (Dimmer) does not go to 100%

  5. My 100 unit Cbus and wiser II randomly faults.

  6. Why would one of my devices not show in 5500SHAC Objects

  7. Lights are ON after power restore

Loading...