Programming dali groups into scenes

Discussion in 'DALI Software' started by Limeburner, Jul 5, 2018.

  1. Limeburner

    Limeburner

    Joined:
    Jul 5, 2018
    Messages:
    6
    Likes Received:
    0
    Location:
    Arrowtown, NZ
    I have a normal cbus network of dimmers and flush plates plus 40 dali dimming ballasts with their own lights. I am using a 5502DAL interface and can make the cbus groups in the mapping section. The issue is I can't access those groups when trying to make scenes as it only show groups in the lighting application group not the dali application group. What am I doing wrong?
     
    Limeburner, Jul 5, 2018
    #1
    1. Advertisements

  2. Limeburner

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    725
    Likes Received:
    20
    Location:
    Adelaide, Australia
    What device are you trying to store the scenes in? In switches that support scenes (aside from the eDLT) you can only control groups in the primary application. The eDLT can control groups in both their primary and secondary applications. Otherwise you will need a device like a touch screen. wiser, shac etc.
     
    Ashley, Jul 6, 2018
    #2
    1. Advertisements

  3. Limeburner

    Limeburner

    Joined:
    Jul 5, 2018
    Messages:
    6
    Likes Received:
    0
    Location:
    Arrowtown, NZ
    Hey thanks there is a wiser going in and edlt so will make them there. Cheers
     
    Limeburner, Jul 6, 2018
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.