Programing SHAC remotely

Discussion in 'C-Bus Automation Controllers' started by julscam03, Jun 14, 2021.

  1. julscam03

    julscam03

    Joined:
    Aug 27, 2020
    Messages:
    14
    Likes Received:
    0
    Hello,

    I am programming a SHAC for a client. The SHAC has not yet been installed into their network.

    Would I be able to program it at my house using their toolkit file, and then install it into their house?

    If so how would I go about doing this in terms of setting the IP address and connecting it to a toolkit file that is not on my network?

    Thanks.
     
    julscam03, Jun 14, 2021
    #1
    1. Advertisements

  2. julscam03

    Jesmond

    Joined:
    May 18, 2005
    Messages:
    107
    Likes Received:
    0
    Location:
    Victoria
    Jesmond, Jun 14, 2021
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.