Problem with Ethernet PCI

Discussion in 'C-Bus Toolkit and C-Gate Software' started by merik, Jan 7, 2007.

  1. merik

    merik

    Joined:
    Jan 20, 2005
    Messages:
    4
    Likes Received:
    0
    Location:
    Canberra
    Hi everyone

    I have encountered a problem with my CBUS system. When I connect to it with Toolkit 1.5.3 and do a scan, everything is fine with the exception of my ethernet interface. It errors with the following:

    Error 2064

    An error has occurred
    The selected C-Bus unit is not supported by this version of C-Bus Toolkit

    I have the latest version. It is obviously working as Toolkit is working through it.

    Any thoughts.

    Regards

    Merik
     
    merik, Jan 7, 2007
    #1
  2. merik

    Duncan

    Joined:
    Jul 23, 2004
    Messages:
    925
    Likes Received:
    0
    Location:
    Salinas de Garci Mendoza, Bolivia
    After you've scanned the Network can you tell what the Unit Type and Firmware Version of the CNI (Ethernet PCI) is? You'll need to scroll across to the right of the list of units to see the Firmware Version..
     
    Duncan, Jan 7, 2007
    #2
  3. merik

    merik

    Joined:
    Jan 20, 2005
    Messages:
    4
    Likes Received:
    0
    Location:
    Canberra
    The unit is a "PCINTETH" and the firmware is 4.0.0

    Thanks

    Merik
     
    merik, Jan 8, 2007
    #3
  4. merik

    Duncan

    Joined:
    Jul 23, 2004
    Messages:
    925
    Likes Received:
    0
    Location:
    Salinas de Garci Mendoza, Bolivia
    Hi Merik,

    It would seem that as part of the C-Bus Enabled Program you might have done something that has caused this problem. I will get the C-Bus Enabled Coordinator to contact you.
     
    Duncan, Jan 8, 2007
    #4
  5. merik

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,391
    Likes Received:
    24
    Location:
    Adelaide, South Australia
    This was referred to technical support. The unit type is strange and not a type programmed in the CIS factory.

    CIS don't understand how a unit could have been supplied with that unit type, and have asked for the unit to be returned for exchange.
     
    ashleigh, Jan 8, 2007
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to run C-Gate under Linux with PCI

  2. PCI Communication with Cbus problem

  3. PAC with ethernet possible?

  4. Problem with PCI and Cbus

  5. Comparing 5500CN Ethernet Interface 5500PC PCI and 5500PCU

  6. Toolkit with Ethernet to Serial converter

  7. Can I do this with C-BUS/Ethernet?

  8. Ethernet PCI Interface firmware

Loading...