Problem with c-bus functioning after power loss

Discussion in 'C-Bus Wired Hardware' started by Nikita.Bagritsevich, Jan 9, 2013.

  1. Nikita.Bagritsevich

    Nikita.Bagritsevich

    Joined:
    May 8, 2012
    Messages:
    11
    Likes Received:
    0
    Location:
    Minsk
    Hello!

    I have problem with c-bus functioning. The installation consists of Wiser with logic on it and c-bus network. The power loss on the site sometimes happen. The Wiser is UPS powered, other DIN-rail modules are placed in switchboards and powered from utility. After site power off for short time the logic running on Wiser is partly unavailable. Some scenarios behave well, some don't. The main concern is thermostats and logic translating their commands to the hardware. What can be done in such situation besides total site power supply improvement?

    thanks,
     
    Nikita.Bagritsevich, Jan 9, 2013
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. DSI Gateway - What happens on power loss?

  2. Problem with C-Touch display after configuration download

  3. C-bus state recall from C-Touch after power failure

  4. C-Touch Power loss monitoring

  5. Wiser control lagging or not functioning at all

  6. Loss of comms to C-Bus, restarting C-gate fixed it

  7. Network problem after power cut

  8. Power ON Multi room audio remote amplifier after power reset?

Loading...