Problem with 5102BCLEDL bus coupler channels

Discussion in 'C-Bus Wired Hardware' started by goodjams, May 24, 2015.

  1. goodjams

    goodjams

    Joined:
    May 24, 2015
    Messages:
    1
    Likes Received:
    0
    Location:
    Melbourne, Australia
    Hi all,

    I'm new to the forum and am having a problem with my bus coupler. I have a cbus installation that is 2 year old that has a 5102BCLEDL bus coupler installed but it is not performing any function at the moment. I plan to use it to monitor 2 roller doors open/close state.

    I was having trouble getting the unit to trigger a group change when the roller door opened, so i disconnected the roller door circuit and changed the led links to actual leds.

    I found that even with no circuits connected to either channel, the leds are on [when Indicator assignment style is set to Status (On) and off when Indicator assignment style is set to Status (invert)].

    Any help/advice you can give me will be gratefully appreciated.
     
    goodjams, May 24, 2015
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Two channels with same name ?

  2. Bus coupler with scenes

  3. Tactile switches for use with bus coupler

  4. B-Coupler with scenes

  5. Switch for 5102BCLEDL

  6. IR key code for C-Bus A-D channels

  7. Is there any problem, If i connect powersupply at load channels..??

  8. Control multiple channels with one wall switch

Loading...