PIR - Return to previous state

Discussion in 'C-Bus Wired Hardware' started by shanede, Nov 1, 2019.

  1. shanede

    shanede

    Joined:
    Dec 17, 2018
    Messages:
    27
    Likes Received:
    0
    Hi,

    is it possible to set a group to its previous state if it is part or a PIR group. I am looking to have 4 groups controlled by a PIR however one or two of the groups may be on prior to being triggered by the sensor. Is it possible to have them return to their previous state and not turn of after the timer, however if they were off then they should turn of.

    thanks
     
    shanede, Nov 1, 2019
    #1
  2. shanede

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,524
    Likes Received:
    173
    Location:
    Adelaide, Australia
    Assuming you are using a Cbus output unit with logic (like a DIN relay or Dimmer), just put the PIR on it's own group, then use the MAX (dimmer) or OR (relay) function of the output unit.
     
    Ashley, Nov 1, 2019
    #2
  3. shanede

    shanede

    Joined:
    Dec 17, 2018
    Messages:
    27
    Likes Received:
    0
    Thanks Ashley, I forgot about using the output logic. That should work great.
     
    shanede, Nov 1, 2019
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. CBUS Residential Installation - Return on Inverstment

  2. Homgate V2.6 doesnt recognise previous install

  3. network state = new?

  4. Retaining Previous scene when power is restored

  5. Enable PIR with light level from another PIR

  6. Restore network to previous level after scene

  7. UserParam doesn't set or return values

  8. Return to main startup screen after no activity on the screen

Loading...