PEIRL as PE and PIR

Discussion in 'C-Bus Toolkit and C-Gate Software' started by filpee, Dec 4, 2008.

  1. filpee

    filpee

    Joined:
    May 31, 2006
    Messages:
    204
    Likes Received:
    0
    Location:
    Western Australia
    Hey guys,


    Whats the best way to setup a PERIL so that:

    PIR only operates after hours
    PE will turn off the light over 400 lux

    The lighting circuit is on a relay.

    My understanding is that I can set a group address to enable/disable the PIR (will this also disable the PE function?) and if I set the relay turn on level to anything over 1% it will turn off (as the PE cannot turn the load fully off?).

    A PAC module will schedule this circuit on off. If possible I dont want to use any logic (in the pac) for this function.
     
    filpee, Dec 4, 2008
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. PIR and scenes

  2. PEIRL Pulsing Group for Light Control - Override Problem

  3. 5753 PEIRL Blue Light?

  4. 5753 PEIRL & Schedule Plus

  5. Peirl Sensitivity settings

  6. Minor movement with 5753 peirl

  7. Enable PIR with light level from another PIR

  8. PEIRL Light Level Maintenance

Loading...