passive infra-red timer

Discussion in 'General Discussion' started by ian rockett, May 10, 2006.

  1. ian rockett

    ian rockett

    Joined:
    Dec 13, 2004
    Messages:
    24
    Likes Received:
    2
    Location:
    Bournemouth UK
    I have a pir in a room to turn off lights after an timed period after last movement. the pir turns off the lights regardless of last movement. any ideas :cool:
     
    ian rockett, May 10, 2006
    #1
  2. ian rockett

    Don

    Joined:
    Aug 4, 2004
    Messages:
    429
    Likes Received:
    0
    Location:
    Townsville, Australia
    Briefly, I would suspect that the unit is not set up correctly. If it is turning the lights ON and OFF, that's half the battle.

    Is the timer interval you want set correctly in the same "block" as the group you want to control?

    Are the key press commands set to the defaults for a PIR sensor?

    If it is a PEIRL unit, the time interval can be "tweaked" with one of the pots on the unit, so if this option is enabled, abd the pot is in the wrong position, it will always look like you have a very short interval.
     
    Don, May 11, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Flashing RED LEDs when a key is pressed.

  2. Infra Scan Settings

  3. Infra Red codes

  4. DLT controlling volume from one button (was: DLT And Infra Red Codes)

  5. Passive Infrared detectors (5753L) showing 'No Serial #'

  6. Passive Infrared Detector help?

  7. Senpill & infra red

  8. Red wire instead of brown

Loading...