Occupancy Control

Discussion in 'General Discussion' started by NickF, Dec 4, 2006.

  1. NickF

    NickF

    Joined:
    Nov 29, 2006
    Messages:
    2
    Likes Received:
    0
    I am using a 5753PEIRL Multi Sensor to sense occupancy to turn certain lights on and to control some lighting scenes using an IR remote. I want to disable the occupancy sensor when the scenes are active. As one lighting group is always used in the scenes, I have used that to disable the occupancy. It seems that the multi sensor does not see the disabling group as on, even though it is controlling it through the scenes. If I control that group from a switch, it is fine. Can anyone help here?
     
    NickF, Dec 4, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Occupancy sensors

  2. Occupancy sensors and A/C vents

  3. SENPILL Light Level and Occupancy.

  4. Occupancy Detection and Sunset Combined

  5. Indoor Occupancy Sensor

  6. Occupancy Sensor mismatch

  7. Sunset Function on SENPILL and Light Level of 77 LUX goes 0 when Occupancy Enabled

  8. SENPILL (Multisensor) Occupancy sensor enabled after power failure

Loading...