No units when i scan my network

Discussion in 'C-Bus Toolkit and C-Gate Software' started by GregB, May 16, 2012.

  1. GregB

    GregB

    Joined:
    May 16, 2012
    Messages:
    8
    Likes Received:
    0
    Location:
    Warrington
    I can connect the C-Bus toolkit to my network through my wiser but when I scan the network I cant find any units. I have a 12 channel relay and a 8 channel dimmer on the network.

    Am I doing something wrong?

    Greg
     
    GregB, May 16, 2012
    #1
  2. GregB

    DarylMc

    Joined:
    Mar 24, 2006
    Messages:
    1,308
    Likes Received:
    49
    Location:
    Cleveland, QLD, Australia
    Does one of the output units have a power supply?
    Do you have your network burden plugged in?
     
    DarylMc, May 17, 2012
    #2
  3. GregB

    GregB

    Joined:
    May 16, 2012
    Messages:
    8
    Likes Received:
    0
    Location:
    Warrington
    I did some reading last night and I overlooked the need for a network burden. I am going to set a software burden and try again!

    Thanks for the help!

    Greg
     
    GregB, May 17, 2012
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.