Master and Slave mechs back to back

Discussion in 'C-Bus Wired Hardware' started by speedmeup, Sep 7, 2023.

  1. speedmeup

    speedmeup

    Joined:
    Jun 30, 2022
    Messages:
    20
    Likes Received:
    0
    Has anyone had any success using 5041NMML and 5041NMS mechs in back-to-back grids? Is the fly-lead long enough for a 90mm stud or is it a standard type of connector that could be extended without too much butchering? I know it's not a big saving but it seems worthwhile to save a bit of current draw as well a few dollars. Cheers
     
    speedmeup, Sep 7, 2023
    #1
  2. speedmeup

    Dasman

    Joined:
    May 5, 2011
    Messages:
    37
    Likes Received:
    5
    Location:
    Adelaide
    I dont think it will be impossible to achieve. Have a look at the picture attached, its not terribly scientific, but should give some wiggle room
     

    Attached Files:

    Dasman, Sep 14, 2023
    #2
    speedmeup likes this.
  3. speedmeup

    speedmeup

    Joined:
    Jun 30, 2022
    Messages:
    20
    Likes Received:
    0
    That's awesome. Thanks Dasman.
     
    speedmeup, Sep 14, 2023
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. MinderPro Slave Module info?

  2. Slave AMP locks on Local

  3. Setting PC to slave when testing Colour C-Touch

  4. Sticky Mechs

  5. Clipsal Dali Mechs and Sensor Programming

  6. Master and Slave

  7. 5500NAC/SHAC acting as Modbus/TCP server (i.e. slave)

Loading...