Making a DLT Dynamic

Discussion in 'Multi-Room Audio (MRA) and MARPA' started by Jesmond, Aug 13, 2006.

  1. Jesmond

    Jesmond

    Joined:
    May 18, 2005
    Messages:
    107
    Likes Received:
    0
    Location:
    Victoria
    Hi Guys,

    A few months ago I saw a DLT programmed to display separate Dynamic Controls depending on which source is selected. I tried to replicate this using the instructions on the MRA installation notes without success. Is there any other literature around the place that can help me work this out ?

    Also I need to purchase (read can't be bothered making) 7 Digital Cables (from Matrix to Remote Amps - all are centrally located so 1 mtr each would do) can anyone advise where I can get these or a Clipsal Code?

    Regards
     
    Jesmond, Aug 13, 2006
    #1
  2. Jesmond

    Darpa

    Joined:
    Apr 30, 2006
    Messages:
    426
    Likes Received:
    0
    Location:
    Australia
    Hey Jes,

    I could be wrong, but I think the "digital" cables between the matrix switcher and the amps is just standard Cat5 cabling, you should be able to get some common sized pre-made cables from most computer stores or an electrical wholesaler.

    Darpa :)
     
    Darpa, Aug 14, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. INFO : making RJ45 lead / cable for Touchscreen & PCI

  2. Making my new home c-bus ready (in the building stage)

  3. Non Dynamic DLT switches

  4. Dynamic button DLT function

  5. making house energy efficient

  6. Dynamic Dlt Labels

  7. DLT Dynamic 2 not displaying correctly

Loading...