Looking for PSU SPU50-1-S01

I am looking for PSU SPU50-1-S01 or alternative and info will be apricated.

 

Yep, looks like what normally goes wrong with em.
No longer available from Clipsal.
Equivalent from jaycar is
Mean well 5v 14amp open frame anout $60 bucks
Just splice it into the existing cables.
Make sure you adjust it up to 5.6volts and use all 4 plus and minus wires
Regards Trevor

 

Can any one conform the pin voltages on pin 3/4 +vcc and pin 1,2 GND as they contradict labeling on power supply.

Thanks in advance

 

Hi,
Your looking at 2 different connections there..
The top picture is of the 4 pin connection from the ac/dc power pack to the extension cable. The lower picture is what is plugged into the touchscreen, this diagram should match the one on the back of the touchscreen.
The safest method would be to cut the cable off the ac/dc power pack, plug then connect the extension cable as well now you will have 4 wires, 2 each of plus and minus, use the diagram on the touchscreen to confirm the correct conductors at each end. Join the 2 plus together and the 2 minus together and then connectvto the new power supply.
And don't forget to turn up the voltage to 5.6 volts.
If you need to please contact me directly on...
0404 887 463
Regards Trevor

 

Thanks Trevor totaly forgot about the plug on the back of the unit.