Logic stops running when I disconnect PICED from the WISER 2

Discussion in 'C-Bus Wiser 2 Controller' started by noyzey, Nov 21, 2018.

  1. noyzey

    noyzey

    Joined:
    Mar 24, 2010
    Messages:
    34
    Likes Received:
    1
    Location:
    Sunshine Coast, Australia
    This is probably a dumb question, but I've written some logic that works perfectly when I have the PC running PICED and connected to C-Bus. I then save the PICED file, transfer the project to the WISER2 and wait 2 minutes.

    When I disconnect from C-Bus, the logic is no longer running.

    The WISER is definitely connected to C-Bus as Scenes are being recalled. I have a green light on the WISER2.
    I have no other systems connected to C_Bus using TCP/IP.

    Any ideas?
     
    noyzey, Nov 21, 2018
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.