Light Level Sensor

Discussion in 'General Discussion' started by suresh, Mar 11, 2009.

  1. suresh

    suresh

    Joined:
    May 19, 2008
    Messages:
    9
    Likes Received:
    0
    Hi,

    I have a requirement that i need to control the Target Lux and Display the Measured Lux of a Lux Level Sensor on the BMS Workstation which has Citect Scada Loaded.

    I have tried using Pascal Controller but unable to do this. Is there any other method to achive this.

    Regards
    Suresh
     
    suresh, Mar 11, 2009
    #1
  2. suresh

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    It is not possible to change the target light level for a light level sensor via C-Bus.

    If you really need to be able to have this sort of feature, you might be better off to use the light level sensor to broadcast the light level and use Citect to implement the control algorithm.
     
    Darren, Mar 11, 2009
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Indoor/Outdoor Light Level Sensor

  2. IP56 weather proof SENLL (light level sensor)

  3. 06-026-1 Light Level Sensor Function

  4. 06-030-1 Multi Sensor As A Light Level Sensor Only

  5. Light Level Sensor Question

  6. curtain control by light level sensor

  7. PACA and Light Level Sensor

  8. Light level broadcast Multi Sensor

Loading...