Homeminder Connection Blues

Discussion in 'C-Bus Wired Hardware' started by floripa, May 23, 2006.

  1. floripa

    floripa

    Joined:
    May 23, 2006
    Messages:
    10
    Likes Received:
    0
    Hoping somone may be able to help me with this one. I have a site which has installed 3 Homeminders across about 7 floors and need to re-program some input units but cannot communicate with the Homeminder through the RS 232 port. I am using the C-Bus toolkit 1.4.0 (build 212) and cannot scan the network to find anything at all. I am sure that my comms port settings are correct and I have been successful connecting using the same format/settings at home on my test bench using a PC interface (5500 PC) and other input and outpus devices. Any ideas guys??

    Thanks;
    Scott.
     
    floripa, May 23, 2006
    #1
  2. floripa

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,400
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    If you are trying to connect THROUGH the HomeMinder, using Toolkit, then the bad news is that this is not possible. You will need to use a cbus PCI to connect Toolkit to cbus.
     
    ashleigh, May 23, 2006
    #2
  3. floripa

    floripa

    Joined:
    May 23, 2006
    Messages:
    10
    Likes Received:
    0
    Ok, Thanks Ashleigh. I'll give that a go.
     
    floripa, May 23, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Do I need a C-Bus PC interface aswell when using HomeMinder

  2. Homeminder versions

  3. CIS Homeminder

  4. Homeminder software

  5. Multi-sensor with the Blues (or rather without...)

  6. CNI connection issues - "connection already in use"

  7. I?ve got the DLT label programming blues

Loading...