Flash Card Updated??

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by Mr Mark, Aug 15, 2006.

  1. Mr Mark

    Mr Mark

    Joined:
    Jan 27, 2006
    Messages:
    323
    Likes Received:
    5
    Location:
    FNQ
    Hello All...

    Installed a new flash card into a client's CTC yesterday.
    It ran for about an hour, before progressively getting chunkier then locking up completely. The client called us out last night, we did a re-start and the screen works again - sort of. It's slow to respond still eg. hold down a key on a dimmer 'button', it stays inert for four seconds before it starts to ramp. A short press is the same - three to four second lag, then the load and indication changes. We checked this morning, the unit is still working but not smoothly.

    I should also add the project ran well with the old card in it for about three months. When we replaced the card, we went through and did the calibration, backlight etc.

    Any ideas ?

    Mark :confused:
     
    Mr Mark, Aug 15, 2006
    #1
  2. Mr Mark

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    Send your project archive into Tech Support so they can see whether they can duplicate your problem.
     
    Darren, Aug 16, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.