Error 14700

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by ajnas, Mar 22, 2012.

  1. ajnas

    ajnas

    Joined:
    Sep 26, 2011
    Messages:
    1
    Likes Received:
    0
    Location:
    kuwait
    My touchscreen gets hanged and shows error 14700. The error box shows 'error communicating with auxiliary processor. No response with command 'Initialise' .
    Should I replace the flash card and check??
    Is this a hardware error? What should I do next? :(
     
    ajnas, Mar 22, 2012
    #1
  2. ajnas

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    Try transferring a very basic project to the Colour C-Touch to see whether there is some aspect of your project leading to this problem.

    You could try swapping the flash card in case there has been some corruption of the operating system or drivers.

    If this makes no difference, then it is most probably a hardware problem. If your Colour C-Touch is out of warranty, you could open it up and wiggle the connectors (particularly to the board on the right hand side at the front) to see if it is caused by a dodgy connection.
     
    Darren, Mar 23, 2012
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.