edlt struggles to display modbus output

Discussion in 'C-Bus Wired Hardware' started by kojobomb, Jan 10, 2022.

  1. kojobomb

    kojobomb

    Joined:
    May 27, 2019
    Messages:
    71
    Likes Received:
    6
    Location:
    Possum Brush
    I have managed to poll a modbus device and display a parameter into SHAC it display in visualisations no problem at all but edlt struggles to display parameter or gets stuck on an output and doesn't update.
    Is there any known reasons why this might be happening?
    it displays 2 temperature parameters without fault but the modbus parameter is really temperamental.
    Ash
     
    kojobomb, Jan 10, 2022
    #1
  2. kojobomb

    kojobomb

    Joined:
    May 27, 2019
    Messages:
    71
    Likes Received:
    6
    Location:
    Possum Brush
    All Sorted, The more mistakes I make the more I am learning.
     
    kojobomb, Jan 11, 2022
    #2
    gte242 likes this.
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. MODBUS protocol

  2. Modbus RS485 to C Bus

  3. ModBus <-> C-Bus?

  4. eDLT display switching on by itself

  5. C-bus to Modbus converter

  6. Modbus Profile Mapping to SolarEdge Inverter

  7. eDLT Firmware Upgrade - Failed to detect an eDLT unit connected to the computer

  8. Logic Help - Adjustable Set Point Temp on eDLT display for Floor Heating

Loading...