eDLT not powering up

Discussion in 'C-Bus Wired Hardware' started by TimC, Nov 5, 2019.

  1. TimC

    TimC

    Joined:
    Oct 25, 2018
    Messages:
    4
    Likes Received:
    0
    I have a couple of eDLTs on my system which work fine and have bought a few more to replace my older DLTs however, when i remove the DLT and plug in the new eDLT it does not power up.

    If I swap out a working eDLT with a new one, the new one powers up. Confused? I am.

    Voltages look good. New flylead continuity is good with no shorting.

    I even tried to put one where i have a B/W screen and it would not work.

    Dates on the eDLTs are Q3 2015.

    All advice gratefully received.
     
    TimC, Nov 5, 2019
    #1
  2. TimC

    Wonkey

    Joined:
    Aug 3, 2004
    Messages:
    395
    Likes Received:
    37
    Location:
    Adelaide
    With you commenting that the new eDlt works in the position where the existing one is and not elsewhere, I presume you used the fly lead installed when connecting to postion where the existing one is.
    Therefore check the flylead again in particular compare the polarity marking against the installed one. It may be incorrectly labeled
    Colin
     
    Wonkey, Nov 5, 2019
    #2
    TimC likes this.
  3. TimC

    TimC

    Joined:
    Oct 25, 2018
    Messages:
    4
    Likes Received:
    0
    Perfect. The Flylead labels are printed upside down!
    Works a treat now.

    Many thanks Colin.
     
    TimC, Nov 5, 2019
    #3
  4. TimC

    Wonkey

    Joined:
    Aug 3, 2004
    Messages:
    395
    Likes Received:
    37
    Location:
    Adelaide
    Good news thanks for the feedback
     
    Wonkey, Nov 5, 2019
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Powering Bathroom Fan over c-bus

  2. Powering the 56001 Audio Distribution Unit.

  3. 5000CTC Not powering up

  4. Powering electric door locks

  5. eDLT Standby Page not displaying date/time

  6. Powering dimmer units

  7. System Continuously Powering Down

  8. eDLT Firmware Upgrade - Failed to detect an eDLT unit connected to the computer

Loading...