Dynamic 1 and 2 not operating as expected

Discussion in 'Multi-Room Audio (MRA) and MARPA' started by Wonkey, Jul 10, 2018.

  1. Wonkey

    Wonkey

    Joined:
    Aug 3, 2004
    Messages:
    112
    Likes Received:
    2
    Location:
    Adelaide
    When using Dynamic 1 and 2 programmed into Matrix switcher and you have selected to use trigger control group as the control method (to allow either IR control), should the relevant trigger control group be seen on the network when Dynamic 1 or 2 is triggered from an eDLT programmed to operate MRA Source Control
    I am not seeing the trigger group and action selection on the network and hece not able to process any further actions in logic.
    See screen grabs below
    Thanks for any help
    Colin

    upload_2018-7-10_20-28-36.png

    upload_2018-7-10_20-35-6.png
     
    Wonkey, Jul 10, 2018
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.