downlight/night light/sensor

Discussion in 'General Discussion' started by Petersteve, Oct 19, 2021.

  1. Petersteve

    Petersteve

    Joined:
    Oct 18, 2021
    Messages:
    7
    Likes Received:
    0
    Hi

    The client would like in the hallway during the day the downlights to come on and after sunset the nightlights to come from the same clipsal PIR sensor.

    I struggling to do this.

    Please kindly help
    I am new to this (as you can probably tell, so apologies in advance)

    Regards
     
    Petersteve, Oct 19, 2021
    #1
    1. Advertisements

  2. Petersteve

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,297
    Likes Received:
    134
    Location:
    Adelaide, Australia
    In the top section for the 'Movement in Light' group select the group for the day lights.
    In 'Movement in Darkness' select the group for the night lights.

    In the Function tabs, for both ML and MD columns select Recall 2, Retrigger Timer, Retrigger Timer and Idle in that order.

    In the blocks tab, set Recall 2 to whatever level you want the lights to come on at for the appropriate group address. Then set the Timer 1 column for the time. Make sure the expiry command is Off Key.
     
    Ashley, Oct 19, 2021
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.