Dongle for c-touch schedules

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by FSS, Jan 7, 2020.

  1. FSS

    FSS

    Joined:
    Sep 9, 2019
    Messages:
    2
    Likes Received:
    0
    Hi, just wondering if a schedule dongle is required to program schedules in a C-touch MK2 with logic screen using PICED? I have done the C-Bus training course but unfortunately this did not cover touch screens at all.
     
    FSS, Jan 7, 2020
    #1
  2. FSS

    chromus

    Joined:
    Jan 27, 2014
    Messages:
    422
    Likes Received:
    50
    Location:
    Perth
    Nope, is built in and open access.

    The schedules are pincode protected in the Menu > Tools section on most skins.

    Side note, if you just want the schedules without buying hardware and you have an available CNI/USB/Serial interface, you can run PICED on a machine and run the schedules from there in the WYSIWYG emulator.
     
    chromus, Jan 7, 2020
    #2
  3. FSS

    chromus

    Joined:
    Jan 27, 2014
    Messages:
    422
    Likes Received:
    50
    Location:
    Perth
    I should add, that the schedules have to be built in PICED, but can be tweaked on the screen.
     
    chromus, Jan 8, 2020
    #3
  4. FSS

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,524
    Likes Received:
    173
    Location:
    Adelaide, Australia
    Just remember PICED will only run in simulation mode for a couple of days before exiting automatically so it's not much of a permanent solution
     
    Ashley, Jan 8, 2020
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. C-touch schedules

  2. Multi-network G-Gate dongle with no Printer port

  3. C-Gate license dongle

  4. Homegate 4 usb dongle

  5. CTouch V3 using wifi dongle

  6. SP USB to Parallel cable for old license dongle

Loading...