done cbus basic training

Discussion in 'General Discussion' started by langer, May 19, 2009.

  1. langer

    langer

    Joined:
    Mar 5, 2009
    Messages:
    3
    Likes Received:
    0
    hi there im a 4th year apprentice electrician, and i have done most of my apprenticeship in the lift industry, i did the cbus basic training course, as when iam licensed i would like to move out of the lift industry. however im not sure what roads to take in becoming a cbus programmer as ive done the course and im a little bit like now what was hoping i could have some help in further steps to becoming a cbus programmer im in Melbourne Victoria
    thank you
     
    langer, May 19, 2009
    #1
    1. Advertisements

  2. langer

    joshl

    Joined:
    May 25, 2008
    Messages:
    67
    Likes Received:
    0
    I did half of the courses in my third year, and now a fourth year finishing off the cbus courses. I knew a sparky that was getting a few cbus jobs, so I tagged along helped wired, did some of the boards, did some of the programming, so thats my advice as an apprentice, did a lot of tagging along on weekends to get the experience and understanding in my own time.:D
     
    joshl, May 19, 2009
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.