Dlt status indicator problem

Discussion in 'C-Bus Wired Hardware' started by raymond8, Sep 29, 2015.

  1. raymond8

    raymond8

    Joined:
    Sep 29, 2015
    Messages:
    2
    Likes Received:
    0
    Location:
    Wellington
    Hi
    I'm new to Cbus, currently setting up my home theatre with Cbus lighting.
    I have a 4 channel dimmer unit, DLT saturn switch and a serial controller unit. I have notice that there is problem with the status indicator on the DLT switch unit. When I push a button on DLT, indicator on the dimmer dimmer unit changes according to the button i push. But when i didn't it in the opposite end i.e.. i push a dimmer button on from the dimmer unit then that change is not register on the DLT unit.

    Can any one help please??
     
    raymond8, Sep 29, 2015
    #1
  2. raymond8

    Conformist

    Joined:
    Aug 4, 2004
    Messages:
    810
    Likes Received:
    91
    Location:
    Adelaide, South Australia
    Hi Raymond

    Pressing the button on the dimmer is putting the dimmer into manual override mode. It is not sending a message onto the bus and therefore the DLT will not see the manual override signal.
     
    Conformist, Sep 29, 2015
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. DLT Scene Indicator

  2. LED Status problem

  3. Controlling DLT screen and indicator brightness from a key?

  4. NEO Scene Status Indicator Problem

  5. Screen and Indicator Brightness on DLT's

  6. Climate Control Widget .. status indicator

  7. DLT Indicator Brightness

  8. CBus-DALI gateway status correction problem

Loading...