DLT hardware

Discussion in 'C-Bus Wired Hardware' started by Dave Byron, Jun 15, 2005.

  1. Dave Byron

    Dave Byron

    Joined:
    Aug 3, 2004
    Messages:
    835
    Likes Received:
    0
    Location:
    Casurina
    Finging that some the cover plates jam the buttons in the DLTs, and the buttons not fully returning.
    Switch fail when this happens.
    Have returned switch to Clipsal Bris for a look.
    Gang holes need to be bigger.


    dave
     
    Dave Byron, Jun 15, 2005
    #1
  2. Dave Byron

    Ross

    Joined:
    Aug 3, 2004
    Messages:
    174
    Likes Received:
    0
    What Dave said, I'm having the same issue.
     
    Ross, Jun 15, 2005
    #2
  3. Dave Byron

    [email protected]

    Joined:
    Oct 30, 2004
    Messages:
    43
    Likes Received:
    0
    Location:
    Iceland
    DLT Issue

    yes I have had the same thing happen, when installing the DLT?s beacuse the base is made of plastic it can warp the slightest bit, and make some of the button stuck, I have found the the dept of the backbox into the wall affects this, i.e. how deep into the wall the backbox is, if I get it a just the right amount it?s not a problem, also if the wall is not 100% streight it can also couse the plastic back part of the DLT to warp, and some of the buttons get stuck.
     
    [email protected], Jun 17, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Hardware Reliability

  2. what happened to hardware?

  3. Use of non Clipsal hardware

  4. Non C-Bus Hardware ?????

  5. New Hardware

  6. Updating of DLT Text in DLT Switch?s

  7. DLT controlling volume from one button (was: DLT And Infra Red Codes)

  8. E-DLT - White for old DLT Glass?

Loading...