dali troubleshooting

Discussion in 'DALI Software' started by banjo, Jan 15, 2009.

  1. banjo

    banjo

    Joined:
    Jan 15, 2009
    Messages:
    2
    Likes Received:
    0
    hi, i am in the process of finishing an eight story building on the dali system i have run into some very big problems when bringing the dali product DC200 onto the network. The DC has caused a loss of memory and changes in the actions of existing groups. the DC200 is operating all sensors as well as switches I really need some help, i am out of ideas. Has anyone used the DC200 if so how did you find them?
     
    banjo, Jan 15, 2009
    #1
  2. banjo

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,389
    Likes Received:
    21
    Location:
    Adelaide, South Australia
    Suggest you find a dali forum. This is really for cbus... C-Bus / DALI via the Clipsal gateway might get you answers here, but if its pure DALI then good luck!
     
    ashleigh, Jan 15, 2009
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.