Dali gateway configuration

Discussion in 'General Discussion' started by nanocubex, Jun 22, 2011.

  1. nanocubex

    nanocubex

    Joined:
    Jun 22, 2011
    Messages:
    4
    Likes Received:
    0
    Location:
    Hong kong
    Dear All,

    Can use the EIB-Dali gateway to assign the Dali ballast address first then Re-connect to the C-bus dali gateway via toolkit to do configuration?
     
    nanocubex, Jun 22, 2011
    #1
  2. nanocubex

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,402
    Likes Received:
    28
    Location:
    Adelaide, South Australia
    I think you might be in the wrong place.

    This forum is for C-Bus, not EIB.
     
    ashleigh, Jun 23, 2011
    #2
  3. nanocubex

    DarylMc

    Joined:
    Mar 24, 2006
    Messages:
    1,326
    Likes Received:
    51
    Location:
    Cleveland, QLD, Australia
    Hello Nanocubex
    If the unit you have can address the ballasts that is OK.
    Map the CBus to DALI addresses when you connect to the CBus interface.
     
    Last edited by a moderator: Jun 23, 2011
    DarylMc, Jun 23, 2011
    #3
  4. nanocubex

    nanocubex

    Joined:
    Jun 22, 2011
    Messages:
    4
    Likes Received:
    0
    Location:
    Hong kong
    It work!

    Thanks DarylMc!
     
    nanocubex, Jul 4, 2011
    #4
  5. nanocubex

    samluo

    Joined:
    Nov 3, 2009
    Messages:
    65
    Likes Received:
    0
    Location:
    SHENZHEN
    YES I think can be OK.
     
    samluo, Jul 8, 2011
    #5
  6. nanocubex

    nanocubex

    Joined:
    Jun 22, 2011
    Messages:
    4
    Likes Received:
    0
    Location:
    Hong kong
    It works!

    Thanks All !
     
    nanocubex, Jul 19, 2011
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.