Concept 4000 Intergration

I have a concept 4000 and CBUs
it is talking on via UART Port 2

I am using windirect to program

I would like to make the Concept use CBUS to turn on the light.

I have set up the PIR in the concept into an area called FZone area.

I have told that Function Zone to Turn on C01:X32 when unseal.

Under CBUS i have told that CB001 to look at C01:X32
I have ticked 2
I have selected ON CMD
My On Group address is 129
On Ramp level is 254
At this i am not even turning it off at the minute.

I walk in front of the PIR and the review says it is in alarm and turns on C01:X32. However CBus does nothing.

In review when i manually press the button in the Toilet it shows up as #129 is On by CT002 CBus #129 now on
Any ideas on where to from here?

Please can someone help i dont have much hair left.

 

You say you have ticked 2 are you talking about use application 2 in the programming?.
If so what is your second application setup too in the c-BUS comms task?
If you set up the 1st appl in comms task for lighting you don't need to tick the 2nd appl in the C-BUS aux programming.

 

2nd application

I only want to use lighting.
i Ticked 2 only because it was there to tick and wasnt working.
I have tried both ticked and unticked.

in review of Concept i can see the Function Zone working and bringing on the aux, however it does not turn on CBUS group.

Also It doesnt turn on manually via Concept Keypad under Aux Control,
But if i press the CBUS light it shows in Review as CBUS #129 On by CT002
Which is Cbus Comms Task.

 

1st Application

Goo
You first application refers to what you want your Concept to control.
In your case it would be lighting.
So in your comms task set it to 38 which is lighting.
If you tick 2 then Cbus would do another control such as power control etc.
PM if you need some more help

Another young player trap,
Even though you see stuff happening on the CBUS in the concept review you only have half the communication happening.