Coms from C-bus to control4

Discussion in 'C-Bus Automation Controllers' started by N.W.B, Apr 4, 2021.

  1. N.W.B

    N.W.B

    Joined:
    Jul 18, 2019
    Messages:
    32
    Likes Received:
    2
    Hi guys, I have a new c-bus - control4 install in progress. Iv been told from the Control4
    Tech I need a 5500pc for coms to control4 for via RS232. I have a Shac in the system already, can you not use the Shacs RS232 instead?
     
    N.W.B, Apr 4, 2021
    #1
  2. N.W.B

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,521
    Likes Received:
    173
    Location:
    Adelaide, Australia
    No. The RS232 on the SHAC is not a Cbus interface. You can use the SHAC as a CNI (i.e. network interface). I'm not sure if control4 supports a CNI though.
     
    Ashley, Apr 4, 2021
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.