Cbus Network time

What's the easiest way to check and change the Cbus network time, I know if I send a piced project to the network it will take my PC time as the current time , but not sure about other ways when above is not possible

 

If you have a touch screen of any type you just set the time and date on that, if its within a short time of current it will just change, if its out by a lot the system will reset as well.

 

If it's keeping time you must have a time keeping device on the network somewhere. A touch screen, DLT, eDLT, Wiser, SHAC , (Old Clock Module). You can change the time from any of those.

 

Thanks for that , now the time is correct and I can confirm while having the application log running, however sunset events are still happening about 1 hour late , despite having a -30 mins offset , I have double checked the location of the project on piced (wiser2) and is all correct , even when I press calculate sunset/sunrise time in project details , it pops up with the correct sunset/sunrise times but the scheduled event's are out by about 1 hour , any idea ? I'm really stuck with this

 

Check your daylight savings setting...

 

Does system time flow through the network bridges? I expect so.