Cbus 8 channel dimmer issue

Discussion in 'General Discussion' started by philfraemohs, Jul 26, 2019.

  1. philfraemohs

    philfraemohs

    Joined:
    Jul 26, 2019
    Messages:
    1
    Likes Received:
    0
    HI there, wondering if anyone can help, i installed an 8 channel 1amp dimmer today, channels 1-4 work fine but channels 5-8 are permanently on, pressing the local buttons does not override it nor does the switch after i had programmed it. so i cannot turn them off. there is no load on them at the moment but i presume that shouldn't make a difference. anyone come across this before?
     
    philfraemohs, Jul 26, 2019
    #1
    1. Advertisements

  2. philfraemohs

    Graham Lamb

    Joined:
    Aug 3, 2004
    Messages:
    24
    Likes Received:
    0
    Location:
    Sydney
    you need to have load connected usually about 25 watts will do it Fluorescent and LED loads sometimes cause trouble.
     
    Graham Lamb, Aug 12, 2019
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.