Can't update C-Touch B/W Firmware from PICED

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by Darren Hunter, Jun 16, 2005.

  1. Darren Hunter

    Darren Hunter

    May 18, 2005
    Likes Received:
    I have PICED 3.1 and Toolkit 1.1.6 connect to CBus via CNI (ethernet interface).
    I can communicate to CBus fine and functions work well in operate mode.
    I can't download from the C-Touch Unit to PICED - get an error. I assumed this is because I'm on firmware 1.9 not 2.0 on the C-Touch B/W so I tried to upgrade the firmware.
    The option under Transfer Project to Unit in PICED for select the firmware file is grayed out (ie. disabled) so I can't access it.

    Any ideas?

    Is it because I'm not COM connected?
    Can it be done via CNI

    Sorry I just realised I posted this in the wrong Forum - I can't move it - if admin can thanks.

    Last edited by a moderator: Jun 16, 2005
    Darren Hunter, Jun 16, 2005
    1. Advertisements

  2. Darren Hunter

    Darren Senior Member

    Jul 29, 2004
    Likes Received:
    Adelaide, South Australia
    You can't transfer a project from a C-Touch to PICED via C-Bus. You must use a serial connection.

    You also can't update firmware via C-Bus. You need a serial connection for this too.
    Darren, Jun 17, 2005
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.